SandbeyDeep well submersible pumpGeneral features of products

　　During adjustment, firstly loosen the support cover, then compress the nut, and then loosen the bearing seat. After adjusting the screw, tighten the compression nut of the bearing seat evenly to make the assembly move towards the pump head. It is necessary to turn the trolley while tightening until the plate does not move. Rotate according to the pump operation　　 Next,SandbeyRubber lining submerged slurry pump, the water seal, lock ring and other parts need to be installed.Sandbey,　　Eliminate hidden dangers of fire pump in time.　　 It is also possible that the fan blades of the pump are few and the air volume is insufficient, resulting in poor heat dissipation effect.Hit,　　Analysis of installation problems of slurry pump For bearings lubricated with thin oil, oil shall be added according to the oil level line of the oil standard before start-up. Add (HL hydraulic oil in winter and (hl hydraulic oil in summer. The bearing lubricating oil of the slurry pump shall be replaced once after continuous operation ( hours.　　 There may also be mechanical failure of the pump, so that the bore will be 'swept' when the stator and rotor rub against each other, or the impeller will be stuck due to impurities such as water and grass when the pump pumps water　　The above is the correct sequence of impeller disassembly of submersible slurry pump. Because different types of pumps have some differences in structure, the stator winding will be burnt out due to excessive temperature rise.　　Operation management of screw pump Nemo pump (single screw pump) is a positive displacement pump, which is widely used in sewage plant to transport sludge and chemicals containing solid particles.　　Water flow into the bearing damages the bearing.Professional is king,　　All kinds of newly designed mechanical seals of submersible slurry pumps contribute greatly to the growth of market share.　　 The standby submersible slurry pump shall roll the shaft / turn every week to make the bearing uniformly accept the static load and external oscillation. The building structure in the water pump room shall be reconstructed. Sound absorbing and isolating plates shall be installed around the wall and on the top of the machine room and fixed with light steel keel; The connecting holes between the machine room and other rooms are tightly blocked,　　When in use, it can drive the impeller to rotate so as to drive it to flow.

　　After the submersible slurry pump leaves the factory, there is generally only outgoing cable,SandbeyHorizontal wear-resistant slurry pump, it will seriously affect the normal operation of the pump,SandbeySelf priming slurry pump wholesale, so we should follow the correct steps to connect.Welcome calls ,　　Wheel, mixing impeller and other main flow passage parts are made of high wear-resistant raw materials, which are wear-resistant, corrosion-resistant, non clogging and have strong sewage discharge capacity, and can effectively pass through large solid particles. It is not limited by suction range, with high slag suction efficiency and more complete desilting. There is no need to equip auxiliary vacuum pump, and the investment is lower.　　 No maintenance: if it is not used continuously after startup, the submersible pump will rust and cannot be started. If it is not used for a long time, do not immerse it in water for a long time. Put it into clean water and run it for a few minutes to clean the mud inside and outside the pump.　　How to disassemble the submersible slurry pump and how to assemble it after disassembly. The technical points and precautions for disassembly will be introduced to avoid disassembly, pump damage and disassembly.Sandbey　　Basically, the reasons for the motor heating of the submersible slurry pump are the above items. If the motor heating occurs, you can find the reasons from the above items. However, it must be noted that if the fault is caused by electricity, people who do not know electricity should not repair it by themselves, so as to avoid people　　Only in this way can its service life be extended to a large extent.　　Stability and reliability of seals between pump bodies.