AnekoskiUsed pipeline pumpEncyclopedia of industry terms
Pump, sewage submersible pump and seawater submersible pump. Therefore, the correct selection of shaft seal can ensure the safe and stable operation of slurry pump.Anekoski Reliability and bearing capacity, extending the service life of the pump. Water flow into the bearing damages the bearing.Corabia, When using the sand pump be sure to pay attention to the steering divergence between the motor and the pump. The sand pump has an arrow on the pump to mark the main steering. After the power supply is connected, be careful not to exceed the bearing on the pump support to avoid First of all, we need to choose equipment with formal certificates when making choices. We must avoid buying some obsolete or inferior products. And sometimes when the pump is in use, multiple pumps need to be used in parallel or standby pumps need to be prepared. Reasonable.
If the water leakage is serious, the broken pipe shall be dismantled and replaced. Lower the lift and press the nozzle of the water pump into the water for .m. The ordinary centrifugal pump may be horizontal end suction type or vertical multi-stage centrifugal type. Third, the whole industrial and mining system operates stably,AnekoskiSubmersible sewage pump, and the operation of the pump will not affect the work of the whole industrial and mining system.Quotation sheet, The pump can often be selected according to the specific requirements of lift, flow and liquid delivery. The flow range of the delivered liquid is - L / s, the pressure range is .- MPa, and the diesel engine speed range is - rpm. Features: water pump, high automation and performance The purpose is to inject liquid higher than . MPa from the water seal ring to prevent gas leakage into the pump when the suction inlet of the submersible slurry pump is in a vacuum state. When the water pressure in the pump is higher than . MPa, the sealing fluid .-. MPa higher than the pressure in the pump can be injected to seal and reduce leakage The above introduction is about the cause ysis of the overload of the slurry pump. When we find these conditions when using the pump we can check whether these reasons are the above. This is also a reminder that we need to maintain the pump during normal use. latent
When the water pump is driven by electricity or diesel engine, its impeller (like an electric fan) rotates wildly, thus forming a vacuum in the impeller. In this way, the atmospheric pressure will move the water pressure to pump water. In fact, from a al point of view, it is to convert electrical or chemical energy into gravityManufacturing cost, If the impeller of the pump is damaged after a long time of use, it will also lead to insufficient liquid supply for the pump. The casing ground wire of the electric pump shall be connected in strict accordance with relevant regulations. When the electric pump is running, it is strictly prohibited to work or move in the water of nearby devices or people, in case of accidents caused by the power distribution of the electric pump. Yes, Fourth,AnekoskiVertical centrifugal slurry pump, model selection parameters: outlet diameter, flow, dust, motor power, impeller speed, pumping rate, maximum particle and weight. If the submersible slurry pump cannot be installed and operated, the blank operation point can be supplemented. When the power supply voltage is too low, the pump will be overloaded, because the pump is also widely used in many rural watering. In this case, so the current in the stator winding will also be