Calleblancos HotelBaigang deep well pumpThe water in the original industry is so deep

　　Carbon, building materials,　　 Take out the locking ring of the coupling, unscrew the fixing screw and remove the connecting bolt to separate the motor and water pump.　　If the shaft seal is not properly selected, it will not only require frequent maintenance during operation, but also leak a large amount of transmitted liquid.Bukama,　　Yes, such mechanical faults will cause the stator winding of the pump to be burnt out.　　When the submersible slurry pump works, the pump needs to be placed on land, the suction pipe needs to be placed in water, and the pump needs to be started. Due to special structural requirements, when the slurry pump motor is submerged in the water, the slurry pump and submerged slurry circulating pump need to be placed above the water surface, otherwise the motor will fall into the water　　 Then replace the pulley and pump cover plate and tighten the fixing nuts.

　　 the submersible slag pump is often used to transport pulp containing solid particles, so the wear resistance of the pipeline should also be considered.　　 The WQ submersible sewage pump has compact overall structure, small volume,Calleblancos HotelDrilling fluid slurry pump,Calleblancos HotelWQ submersible sewage pump, low noise, remarkable energy-saving effect and convenient maintenance. It can work by diving into the water without building a pump house, greatly reducing the project cost.　　Analysis of installation problems of slurry pump For bearings lubricated with thin oil, oil shall be added according to the oil level line of the oil standard before start-up. Add (HL hydraulic oil in winter and (hl hydraulic oil in summer. The bearing lubricating oil of the slurry pump shall be replaced once after continuous operation ( hours.market,　　Friction. Because if the surface of the pump is smooth when it is used, the equipment will consume less energy when it is used. Generally, the submersible slurry pump and impeller are sprayed with polymer composite materials for use　　There will be no insufficient liquid supply or other problems.　　 Then replace the pulley and pump cover plate and tighten the fixing nuts.

　　The production department has to spend a lot of money to maintain and update the pump every year. The pumps made of cast iron, bronze, rubber lining, stainless steel, titanium alloy and other materials used in China&#;s mining, chemical and water conservancy projects on the Yellow River are prone to wear, short service life and many faultswhere　　Submersible slurry pump In addition,Calleblancos HotelFire deep well pump, the sewage pump is usually driven by a motor which also requires some time og quantity when switching on and off, so in fact, it can be adjusted to a certain extent during use. The submersible slurry pump needs to use a line when in use　　The main and feature of self-priming pump is self-priming capacity. How to improve the performance of the pump and obtain large profits requires the following points: first, the discharge valve must be opened to start the self-priming pump, so that the gas can be discharged from the discharge port. Secondly there should be enough liquid in the cavity of the self-priming pump, otherwise it will not　　In fact, when the submersible slurry pump is blocked during use, it will not only have a certain impact on the working efficiency of the equipment during operation, but also cause serious damage to the equipment itself,　　 in addition, the noise method directly detects the noise of the equipment in the detection process, but such measurement will also be affected by the surrounding noise, so in fact, such measurement is not very accurate.　　After understanding the working principle of the submersible slurry pump, we will also know that those parts are prone to wear during normal use. In this way, we can carry out targeted anti-corrosion and wear-resistant treatment on these parts during optimization, so as to improve the integrity of the equipment and　　 Pipeline layout: Firmly support the water pipe and drain pipe to prevent the force of the pipe from acting on the submersible slurry pump.