San MarcosFloor leather constructionCommon problems and troubleshooting

The flame retardant grade is B, there will be traces and traces.Carefully apply according to the wood grain direction of the wood floor. Do not apply or the thickness is uneven.Too little application will cause uneven thickness, and too much application will lead to poor film formation.Keeping thin and uniform is the key to waxing.Do not dilute the floor wax with water.Solid wax must be ground after polishing.San Marcos,Although there are millions of wood species, there are not many suitable wood for flooring.According to GB / t national standard for solid wood flooring, the national standard for solid wood flooring in China is coniferous wood with air dry density not less than .g/cm and broad-leaved wood with air dry density not less than .g/cm The main applicable wood species under this standard are oak (oak)(there are different opinions about oak. The store will say the same. On the Internet, some say oak but some say oak), two winged bean birch, muscarine, round bean, teak, elm, ash (Fraxinus mandshurica), iron sapphire, etc. if it exceeds this range, it should be carefully considered, otherwise the quality is not good or the price is unbearable.The surface is treated with special technology, it will not be like the ordinary wooden floor. Once it bubbles, it will deform and bubble, or it will become moldy due to high humidity.Pickering,People who have a certain understanding of the manufacturing process of composite wood flooring should know that adhesive is essential, but the whole process of SPC flooring is not adhesive (adhesive releases formaldehyde at high temperature), environmental protection. The real formaldehyde is quickly distinguished from many wood flooring materials, and is more and more loved and used by owners.However, it does not refer to formaldehyde, but refers to that the formaldehyde emission is less than .mg/l, and the harm is small.Fifth, the total thickness of the floor is about , cm, which is also related to his total price. Ecological environment protection the patent of the utility model has the advantages of being conducive to installation and maintenance, and prevents the defects of strengthening the composite floor, such as high formaldehyde content standard, astringent upper feet and so on.

We hope these techniques will help simplify the plan for installing new floors.If you plan to renovate your house and add new floor elements, please provide room sizes free of charge!Obtain expert estimates to understand how many floors are needed to better determine the project budget.SPC floor is composed of thickened wear-resistant layer, UV layer, color film texture layer and substrate layer.European and American countries call this kind of floor RVP (rigid vinyl plate), rigid plastic floor.The base material is a composite plate made of stone powder and thermoplastic polymer materials after mixing evenly and then extruded at high temperature. At the same time, it has the properties and characteristics of wood and plastics to ensure the strength and toughness of the floor.Wear resistant layer: PVC transparent wear-resistant layer, with a thickness of about .mm, transparent texture, strong adhesion, wear resistance and scratch resistance, and the wear-resistant coefficient can reach - revolutions.[]Two winged beans: thick and expensive.Third, it is flame retardant, but it can&#;t be burned.details,In case of large-scale immersion or partial long-term immersion in water accidentally, if there is any leveling stay, it shall be immediately sucked away with a dry rag and allowed to be dry. It is forbidden to use an electric water heater to carry out dry or expose to the sun.Again, ask what kind of material is the veneer on the floor (because the prices of different materials vary greatly).Applicable part editing voice

Main performance.Where can I find it?, Ecological environment protection the patent of the utility model has the advantages of being conducive to installation and maintenance, and prevents the defects of strengthening the composite floor, astringent upper feet and so on.The reinforced composite floor with good base material will give off a fresh wooden smell. The composite floor with weak base material will produce a strong pungent smell. The author randomly picked up two wooden floors and put them in front of his nose. The pungent smell from one wooden floor made the author frown immediately. Customers may wish to smell the floor closely when purchasing,San MarcosWaterproof practice of toilet floor,San MarcosCleaning and maintenance methods of wood floor at home, and do not buy inferior floors.From the perspective of environmental protection, the thin one is better than the thick one. Because the thin one uses less glue per unit area. The thick one has less density than the thin one, and the impact resistance is poor but the foot feel is slightly better. In fact, there is little difference between the two. In fact, there is no difference between the thickness and quality of the two kinds of floors. The key is to see personal choice.San Marcos,Compared with laminate flooring: pattern non laminate flooring.Comparison with solid wood flooring: strong glue must be selected for the production of solid wood composite flooring. Unlike the traditional solid wood flooring, only the wood itself is basically with glue.Although the environmental protection quality of super glue is very high, and the formaldehyde concentration can be basically ignored, many colors, complete styles and low-carbon environmental protection performance,San MarcosHigh grade floor leather, it can be widely used in kindergartens, hospitals, offices, office buildings, shopping malls, homes, KTV and other public places. Ecological and environmental protection.