Kawasa LakeVertical slurry pumpMeasures to reduce energy release

it will also lead to the burning of the motor.　　At the same time, the supporting pipelines in the pump room shall be provided with vibration isolation elasticity.Kawasa Lake,　　 particle size (maximum and minimum) mm　　The above is about how to replace the water seal of Boshan submersible slurry pump. In addition to the water seal, other parts of the pump also need to be replaced in time when they are damaged. Moreover, some parts of the pump are relatively easy to be damaged,Kawasa LakeAh slurry pump, so we need to replace them regularly during use　　Check whether it needs to be replaced.Ajmer,　　The pump should be divided into two aspects: electricity and machinery. As for machinery, so it has an irreplaceable position when it is used. What is its own structure when it is used.　　Analysis of installation problems of slurry pump For bearings lubricated with thin oil, oil shall be added according to the oil level line of the oil standard before start-up. Add (HL hydraulic oil in winter and (hl hydraulic oil in summer. The bearing lubricating oil of the slurry pump shall be replaced once after continuous operation ( hours.

　　Circumference. In the application of slurry pump, we must pay attention to reasonable design, correct calculation and appropriate type selection, which are very important. In addition to the main wheel, a set of stirring impeller is added at the bottom of the product, which can spray the precipitated slag into a mixture of water and solid particles　　. Check and solve the problems such as power line disconnection, cable connection, motor winding not burnt, etc.　　 bind the exposed copper wire to the cable core evenly, heat it with an electric iron, and infiltrate tin evenly.new product,　　Compared with the vertical slurry pump, the application market is also larger. In addition to the existing industrial and mining applications of the vertical slurry pump, the submersible slurry pump can also be used as a mobile slurry pump, such as sand pumping on board, prospecting etc; Submersible slurry pump assembly workshop III. what are the advantages of submersible slurry pump　　Slurry pump Inappropriate model is selected when selecting the pump. In actual use, when the load conditions do not match the model of the slurry pump,Kawasa LakeCentrifugal slurry pump, for example, the pump lift used is too high or too low, which will lead to overload, the pump head shall be determined by enlarging the margin of % - %.Discount,　　With water, you can start working.　　The motor burns out the winding due to heat dissipation. The water pump shall be lifted and lowered at any time with the change of water level in the well. In case of water reduction or interruption, the cause shall be found out immediately or the pump shall be shut down for inspection. The cable shall not rub against the shaft wall to prevent the well water from penetrating into the motor along the cable core after the cable is worn.　　 When starting the slurry pump, the outlet gate valve shall be (closed or slightly opened by /. Before starting the slurry pump, expand the pump inlet valve and close the pump outlet valve. Then start the pump. After the pump is started, slowly start the pump outlet valve. The size and speed of opening the pump outlet valve should be based on the fact that the pump does not vibrate and the motorKawasa Lake,　　Superior, complete protection s,Kawasa LakeHorizontal slurry pump, reasonable structure convenient installation and high cost performance. In case of sudden power failure of the plant and emergency, the water pump will automatically start to supplement the pipe network pressure.　　All kinds of newly designed mechanical seals of submersible slurry pumps contribute greatly to the growth of market share.　　Friction. Because if the surface of the pump is smooth when it is used, the equipment will consume less energy when it is used. Generally the submersible slurry pump and impeller are sprayed with polymer composite materials for use