Punta Cana Corrosive pipeline pumpInspection and maintenance work

466HP159575805   ·  2023-03-13 03:10:35   ·   Machinery and industry equipment

  How to avoid this situation when the equipment is in use.   It is also possible that the fan blades of the pump are few and the air volume is insufficient, resulting in poor heat dissipation effect.Punta Cana ,  Some protection s are beyond the reach of manual operation.  It is occasionally found that there is insufficient liquid supply when using, so what are the reasons for this situation and how to deal with it.Pattoki,   The standby submersible slurry pump shall roll the shaft / turn every week to make the bearing uniformly accept the static load and external oscillation. The building structure in the water pump room shall be reconstructed. Sound absorbing and isolating plates shall be installed around the wall and on the top of the machine room and fixed with light steel keel; The connecting holes between the machine room and other rooms are tightly blocked,  When the equipment is in use, the water delivered in the pump receives the friction with the surface of the pump impeller, so the pump needs to consume more energy to reduce the friction and resistance caused by the surface when it is rotating. Water will slowly overcome it as it flows  Its main features are as follows: the whole machine is a dry-type motor pump structure. The motor is protected by mechanical seal,Punta Cana Double suction slurry pump, which can effectively prevent high-pressure water and impurities from entering the motor cavity. In addition to the main impeller, it is also equipped with a mixing impeller, which can pump out the slag settled at the bottom after stirring into turbulence. impeller


Punta Cana Corrosive pipeline pumpInspection and maintenance work



  It is not correct that it has no effect on us.   whether pre lubrication water tank is required  Reasonable.Encyclopedic knowledge,  Now you know the reason why the pump has air turbidity. In fact, this is a very common phenomenon. You don&#;t have to worry about it. Water pump can transport many things such as water, oil, liquid metal, acid-base night and so on. It is a good means of transport.  It can also be used for cooling and lubrication. Once the temperature in the water pump is too high, the pump shall be stopped immediately for maintenance. Otherwise, but also seriously affect the working efficiency of the equipment. So what is the reason for the high temperature of the equipment  In the application of pumps, the first thing we think of is water. Whether it is drinking water or coefficient water, even the polluted water in cities needs to be purified. All these require its equipment to provide services for us. Without pumps, our basic survival is a problem.


Punta Cana Corrosive pipeline pumpInspection and maintenance work



  Work no noise and vibration, and the site is cleaner.Quality management,Punta Cana Centrifugal slurry pump,  How to avoid this situation when the equipment is in use.  (c) The minimum ambient air temperature is - ℃.   During the installation of smooth bearing components, if the installation is correct,Punta Cana Submersible non clogging slurry pump, the smooth oil is appropriate, the repair is timely, and the delivery life will be long, check the condition of the bearings and the smooth oil, and regularly add or replace the smooth oil during the work, and the interval and writePunta Cana ,  It is located in the middle, so it seems that many regions have good effects when using it.  It will burn out. If there is a heating problem in use, you can refer to the following reasons.  There will be no insufficient liquid supply or other problems.

0 Replies   |  until 2023-03-13 03:10:35 | 129 Views
Log inContent can only be published later