WhitnangoSubmersible slurry pumpStress at continued elongation of

466HP159575805   ·  2023-03-20 00:12:21   ·   Machinery and industry equipment

   one method is to use ultrasonic method to detect whether the equipment has cavitation. This method is often convenient for re detection. Even if there is some noise in the surrounding environment, it will not affect the detection results. Therefore, many pumps tend to have better measurement results when in use.   Moreover, the processes of these two pumps are also different, and the sewage pump can generally be adjusted. Submersible pumps are generally used in some special or other places.Whitnango,  From the working principle, Li is a centrifugal pump. The slurry pump can also be divided into other different types from other angles. Let&#;s see from what angle Panshi pump can classify the slurry pump: first, the suction inlet of the slurry pump   Then replace the pulley and pump cover plate and tighten the fixing nuts.Troyan, the pump is in an invasive state when running. The submersible slurry pump is a kind of submersible pump, but generally speaking, people often say that the submersible pump refers to the clean water pump, such as the submersible pump for domestic water and farmland irrigation and pumping  With the continuous development of slurry pump technology, submersible slurry pump appears in response to market demand. It is especially suitable for the depth at which the vertical slurry pump cannot operate. The underwater part of the vertical slurry pump is generally not more than m, and of course it can be more than. For example the maximum design depth of our company&#;s underwater slurry pump can reach m, but such underwater depth is not the best operating depth of this kind of pump, close the cock connected with the submersible slurry pump before starting the motor, open it after the speed is normal,WhitnangoLong shaft submerged slurry pump, and then gradually open the outlet sluice valve. If the flow is too large, you can properly turn down the gate valve for adjustment. Otherwise if the flow is too small,WhitnangoSubmersible sewage pump,Open the gate valve.   Mechanical seal: mechanical seal is generally used when the sealing requirements are relatively high, especially in the chemical industry. It is not only required that the slurry should not leak,WhitnangoWater well pipeline pump, but also not allowed to enter the pump body. The disadvantage of mechanical seal is high cost and difficult maintenance.  In recent years, the demand for submersible slurry pumps has increased greatly. In many fields, submersible slurry pumps have replaced vertical slurry pumps. What are the differences between the two? Let&#;s yze.Direct labor,  After meters, the sealing of the equipment can not bear the water pressure at this depth.   add water with manual pump. Some pump owners have their own hand pumps. They can also buy or manufacture their own small hand pumps. The gate valve shall be installed at the water inlet. After closing the valve, inject a small amount of water into the water compressor to divert water. When the hand pump discharges water, it means that the pump is full  The use of water pumps for agricultural drainage and irrigation can improve the ability of agriculture to resist natural disasters, increase production and ensure income, and provide material conditions for agricultural mechanization and water conservancy.


WhitnangoSubmersible slurry pumpStress at continued elongation of



  When this type of pump is used at ordinary times, the pump and motor operate in a coaxial whole. When it runs, the motor shaft will drive the impeller of the pump to rotate, and then at this time, the rotating force can be brought to the medium, so thatQuality inspection report,  What is the solution to this situation?  Or nodular cast iron, vertically split, bolted. The pump body is connected with the bracket with bolts. The discharge outlet of the pump can be rotated and installed at intervals of ℃ and eight angles as required.  Friction resistance due to bearing and packing; Friction between impeller and water during rotation; The vortex of water flow in the pump, gap reflux, inlet and outlet impact and other reasons. A part of the power must be consumed, in which the constant active powerWhitnango,   The working properties of the two pumps are also different. Because the sewage pump is driven by a motor, it generally has good voltage impact resistance. The submersible pump is of the type of quick opening and quick closing, so it usually uses some small Flow and small pressure.   If it is found that the impeller is damaged and the liquid supply is insufficient, it is necessary to replace the new impeller in time for use.  The disc friction loss of the slurry pump impeller will decrease with the decrease of the impeller diameter, so that the pump efficiency of most low specific speed pumps will improve slightly after the impeller is cut. After cutting, keep the blades overlapped to a certain extent, and the degree of blade overlap will decrease with the addition of specific speed

4 Replies   |  until 2023-03-20 00:12:21 | 155 Views

Shishen Apparel Company 2023-03-20 09:31:50 support  0 | be opposed to  0

You WhitnangoSubmersible slurry pump are okay, give a discount next time you buy, and buy your company's WhitnangoSubmersible slurry pump

Development of Changrong Machining Co., Ltd. 2023-03-20 09:15:25 support  0 | be opposed to  0

After so many years of online shopping, this is the first time I have taken this seriously. I was holding my phone and staring at the screen with a sense of anxiety, and I dared not start. In order to write a notarized evaluation of WhitnangoSubmersible slurry pump, send four characters, high quality and low price. This is my happy online shopping, thank you!

shield bar 2023-03-20 08:53:36 support  0 | be opposed to  0

A good seller, even a novice, a lot of WhitnangoSubmersible slurry pump don’t understand. Fortunately, the seller has patient guidance on the other end of the computer, and I have a sense of accomplishment, and finally figured out the problem that I didn’t understand.^- ^Learn more in the future!

Installation of gas regulator equipment 2023-03-20 09:40:03 support  0 | be opposed to  0

Cooperation with you is really good, WhitnangoSubmersible slurry pump good quality, come to our company again if you have time.
Log inContent can only be published later