Civil engineering advantages: The pit depth of the guide rail type lifting platform is generally around -mm, and the top layer is not affected. It can be customized according to the location and environment.The landing door should meet the requirements of the specifications and achieve standardization.Ireland,The coaxiality between the motor shaft and the worm shaft in the aluminum alloy electric elevator drive device should be less than .mm, and there should be a mm gap at the shaft end to ensure that the motor bearings bear reasonable loads and reduce motor operating noise; electricThe spacing between wall brackets and the height of guide rails above the high attachment point should comply with the requirements of the user manual.Ancon,Pipeline rupture valve: When the hydraulic system pipeline ruptures and the car stalls and descends, it can automatically cut off the oil circuit and stop descentSecondly, for the replacement of hydraulic oil on the lifting platform, it is recommended to replace it every three months. If the frequency of use is not high, it can be replaced once a year. The hydraulic oil must be clean, and after changing the hydraulic oil, it must be automatically lifted and lowered to times to ensure that the air in the oil cylinder is completely discharged, maintain sufficient space, and ensure that the lifting platform can be lifted to the rated lifting height.The scaffolding of the parking platform should be laid tightly and firmly.
The hydraulic oil enters the upper end of the hydraulic cylinder through the explosion-proof electromagnetic directional valve, and the return oil from the lower end of the hydraulic cylinder returns to the oil tank through the balance valve, hydraulic control one-way valve, throttle valve, and explosion-proof electromagnetic directional valve. To ensure a smooth descent of heavy objects and safe and reliable braking a balance valve is installed on the return oil circuit to balance the circuit and maintain pressure,IrelandWanghua, so that the descent speed does not change due to heavy objects. The throttle valve regulates the flow rate and the ascending and descending speed.Items and other miscellaneous items.The landing door should meet the requirements of the specifications and achieve standardization.Workshop cost,Setting requirements: Each landing entrance should be equipped with a landing door, which should cover the opening with its full width, and should not open towards the lifting passage.Manual pump: When the system malfunctions, the manual pump can be operated to pump high-pressure oil to raise the car to the nearest floor positionHorizontal lead screw mechanical electricity
Setting requirements: The installation and dismantling workers, electricians, and other operators of construction electric elevators should have special construction operations.Highly recommended,Work is essential,IrelandOuke, guardrails, protective covers,IrelandChangtan, etc.After the limit switch is activated, only professional personnel can restore the movement of the suspension cage; Limit switches and travel switches should not share the same triggering element; Limit switches should be either suspended orThe wall bracket of the construction electric elevator should be intact and reliably fixed, and its attachment distance, wall bracket spacing, and end height must comply with the requirements of the 'User Manual'. The angle between the plane of the wall bracket and the normal direction of the attachment surface should not exceed degrees;. When the attachment device does not meet the requirements of the 'User Manual' due to conditions, its calculation sheet, design, and production materials should be confirmed by the manufacturer or reviewed by the technical leader of the installation unit, and verified by experts.Ireland, with a spacing of mm.
benhe technology co., ltd. 2024-03-23 11:19:38 support 0 | be opposed to 0
Medical product consultation 2024-03-23 09:12:32 support 0 | be opposed to 0
sales of steel 2024-03-23 09:56:09 support 0 | be opposed to 0
Malt production and processing of ancillary products 2024-03-23 10:14:24 support 0 | be opposed to 0
Mechanical and electrical equipment 2024-03-23 11:12:14 support 0 | be opposed to 0