CotiolahtiSelf priming slurry pump wholesaleBe careful when using

　　Under the action of auxiliary devices, it can transport the slurry and because the sealing device itself is special, so that the pressure at both ends of the equipment can be balanced during normal use　　However it can also ensure the internal and external balance of the submersible slurry pump during transportation, that is, it takes some energy on the auxiliary impeller of the submersible slurry pump, which is generally about %. However, as long as the planning is reasonable, this part of the lost flow can be reduced. The slurry pump is mainly applicable to electric power, metallurgy and coalCotiolahti,　　Shaft seal water, no dilution of pulp, good shaft seal effect. It can be used when the slurry is not allowed to be diluted.　　Commodity.Sinj,　　Submersible slurry pump Use ultrasonic method to detect whether there is cavitation in the submersible slurry pump. This method is often convenient for re detection. Even if there is some noise in the surrounding environment, it will not affect the detection results. Therefore, many pumps often have better measurement results when in use.　　 strip the outer layer of the cable to expose the copper wire for to mm, gradually thin the rubber near the wire core, grind it to the oxide layer on the wire core,CotiolahtiCorrosive pipeline pump, wipe the wire core with alcohol (or hydrochloric acid), wrap the insulation layer and sheath layer, and dry it naturally.　　Commodity.

　　It is not correct that it has no effect on us.　　Replace the ball bearing of the motor.　　Promote the continuous expansion of the sales network group.Customer first,　　In addition to the main impeller inside the equipment, a set of impeller for mixing will be added at the bottom of the equipment so that some mortar slowly settled inside the equipment can be mixed with water to become a flowing medium, so that the equipment can be used without its　　It can also be used for cooling and lubrication. Once the temperature in the water pump is too high, the pump shall be stopped immediately for maintenance. Otherwise, the excessive temperature will not only affect the wear of small parts inside the equipment, but also seriously affect the working efficiency of the equipment. So what is the reason for the high temperature of the equipment　　The of descending axial force can be used for slurry transportation in power plants, hydraulic and other professions; The mechanical seal is tight and reliable, and the leakage probability does not exceed drops /min, which is mostly used to transport flammable, explosive, toxic, strong corrosive and valuable liquids or materials with high temperature, high pressure and low temperature.

　　Pump. In addition, the submersible slurry pump is mainly characterized by 'slurry',CotiolahtiPipeline pump, which is wear-resistant and particle passing.Safety and health,　　What is the order.　　If there is no liquid in the cavity of the self-priming centrifugal pump of the submersible sewage pump, the gas-liquid foam mixture cannot be formed and the air cannot be pumped. In order to ensure the speed and reliability of air extraction, sufficient liquid should be filled in the pump cavity before starting. What time would you like　　 the front and rear bearing glands are equipped with oil seals, which are padded with green paper or asbestos. There is a gap of .- mm between the rear gland and the bearing.Cotiolahti,　　 During the installation of smooth bearing components, the smooth oil is appropriate,CotiolahtiSplit vertical pipeline pump, and the delivery life will be long, the repair personnel should regularly repair the bearing components, check the condition of the bearings and the smooth oil, and regularly add or replace the smooth oil during the work, and the interval and write　　In fact, when the submersible slurry pump is blocked during use, it will not only have a certain impact on the working efficiency of the equipment during operation, but also cause serious damage to the equipment itself, so it is also a reminder that we are using it too　　The premise of using this method is that the water gun must have sufficient flow during use, otherwise the effect of the submersible slurry pump may not be obvious.